Close the water supply valve to the toilet tank.
Water tank for toilet flushing.
Turn on the water to fill the toilet tank.
When you turn the water supply back on immediately check for leaks and tighten the nuts more if necessary.
The trip lever is located on the front of the tank and the tank uses just over 1 1 4 gal.
Once the float gets to a certain height the fill valve closes.
The ncc opp toilet tank only in white the ncc opp toilet tank only in white is made from ceramic for durability and features a gravity fed flush system.
When you flush the toilet the water flows from the tank into the bowl and the float drops which opens the fill valve and allows new water to enter the tank.
3 replace the toilet tank bolts at.
Once that s done open the fill valve and use white vinegar to clean it.
Leave the vinegar there for a couple of hours.
Turn off the water supply and flush the toilet until the tank is empty.
Empty the tank by flushing the toilet until near empty then soak up the remaining water using a towel or sponge.
Pinch the spring clip and slide the float up or down to set the water level one inch below the top of the overflow tube or to the water line marked on the tank.